Insights

Surface Preparation Standards: Sa 1, Sa 2, Sa 2.5 and Sa 3 Explained

May 12, 2026 Vands Engineering Team 2 min read
Surface preparation standards Sa grades guide

Before any protective coating goes onto steel, the surface must be cleaned to a defined standard. The international system used worldwide ÔÇö ISO 8501-1 Swedish Standards ÔÇö defines four cleanliness grades: Sa 1, Sa 2, Sa 2.5 and Sa 3. Getting this right is the difference between a 2-year coating life and 15+ years.

Sa 1 ÔÇö Light Blast Cleaning

Removes loose mill scale, loose rust and loose paint. Tightly adhering contaminants remain. Suitable for short-term protective coatings or where original coating quality matters less.

Sa 2 ÔÇö Thorough Blast Cleaning

Removes almost all mill scale, rust and foreign matter. Acceptable for general atmospheric exposure (interior steel, painted equipment).

Sa 2.5 ÔÇö Very Thorough Blast Cleaning

Industry workhorse. Removes 95%+ of mill scale, rust, paint. Only slight shadows or discolouration permitted. Required for most heavy-duty epoxy, polyurethane and zinc-rich primer coatings.

Sa 3 ÔÇö Blast Cleaning to Visually Clean Steel (White Metal)

Absolute cleanest grade ÔÇö surface uniformly grey/white with no contamination visible. Required for offshore, marine immersion, chemical resistance and ultra-long-life systems (25+ year warranty).

Choosing Abrasive for Each Grade

  • Sa 2 / Sa 2.5: Steel grit G18 / S110 or copper slag
  • Sa 3: Steel grit + finer grit pass, or aluminium oxide for premium finish
  • Restoration work: Glass beads (won't damage substrate)

Surface Profile (Anchor Pattern)

Beyond cleanliness, the surface roughness matters for coating adhesion. Typical anchor pattern:

  • Thin coatings: 25-40 microns Rz
  • Standard epoxy systems: 50-75 microns Rz
  • Thick film & flake coatings: 75-100 microns Rz

Verify with a digital Almen gauge (post-peening) and DFT gauge after coating cures.

Inspection Equipment

  • Almen Gauge MSSD Digital ÔÇö peening intensity verification
  • WFT Gauge ÔÇö wet film thickness during application
  • DFT Gauge ÔÇö dry film thickness after cure

Talk to our team for a complete surface-prep + coating-inspection toolkit tailored to your project specs.

Need engineering advice on this topic? Our team responds within 24 hours with a tailored solution.
WhatsApp