Pu Grouting

PU Grouting for Concrete Crack Repair: Complete Step-by-Step Guide

May 18, 2026 Vands Engineering Team 2 min read
PU grouting machine repairing concrete crack

Concrete cracks are inevitable in industrial floors, basement slabs, retaining walls and bridge decks — but left untreated they widen, leak and compromise structural integrity. Polyurethane (PU) injection grouting is the modern industry-standard fix for sealing active cracks and stopping water ingress.

What is PU Grouting?

PU grouting involves injecting a two-component polyurethane resin into the crack under high pressure using a specialized 2K injection grouting machine. The PU resin reacts with moisture, expanding 20-30x its original volume and curing into a flexible, watertight seal that bonds permanently with concrete.

When to Use PU Grouting

  • Active water leakage through cracks in basements, sumps or retaining walls
  • Cold joints in concrete construction where two pours meet
  • Honeycomb defects in cast concrete elements
  • Expansion joint failures on terraces and bridge decks
  • Cracks in industrial flooring that flex with thermal cycling

Step-by-Step Process

  1. Survey the crack: Map crack length, width and depth. Identify entry and exit points.
  2. Drill injection ports: Drill 12-14 mm holes at 45° to the crack at 150-300 mm intervals along the crack length.
  3. Install packers: Insert mechanical or grout packers into the drilled holes and tighten.
  4. Flush with water: Inject clean water to clear debris and pre-wet the substrate (water activates PU expansion).
  5. Inject PU resin: Using a 2K PU grouting machine at 100-200 bar pressure, inject resin until refusal or until grout appears at adjacent packer.
  6. Move sequentially: Inject the lowest packer first, work upward and outward.
  7. Remove packers & finish: Once cured (typically 24 hours), remove packers and patch the drill holes with non-shrink mortar.

Choosing the Right PU Grouting Machine

Look for these features when selecting equipment:

  • Pressure rating: Industrial machines deliver 150-300 bar for deep penetration into hairline cracks
  • 2K mixing system: Accurate 1:1 ratio mixing of Part A (resin) + Part B (catalyst)
  • Heated material lines: For consistent viscosity in cold conditions
  • Stainless steel pump: Resistant to the abrasive nature of PU resins
  • Brand support: Authorized dealer with genuine spare parts (Graco, Acme range)

Cost vs. Benefit

While PU grouting machines represent a capital investment of ₹2-8 lakh depending on capacity, the savings vs. labour-intensive epoxy crack repair or full slab replacement are substantial. A trained 2-person team can seal 40-80 metres of crack per day with the right equipment — payback within 3-6 months for active repair contractors.

Common Mistakes to Avoid

  • Skipping the water flush — resulting in poor adhesion and incomplete fill
  • Drilling packers parallel to the crack instead of at 45° — missing intersection
  • Using single-component PU instead of 2K — incomplete cure under pressure
  • Not pre-heating PU resin in winter — viscosity too high for injection
  • Re-using cured packers — leakage from previous repair points

Vands Engineering PU Grouting Solutions

Vands Engineering supplies professional 2K PU injection grouting machines for contractors and infrastructure projects across India. Our equipment is engineered for site-grade durability with manufacturer warranty and stocked spare parts. Get in touch for a project-specific quote.

Need engineering advice on this topic? Our team responds within 24 hours with a tailored solution.
WhatsApp